|
In association with
|
| ? |
Jorgensen 50XXX 3/4" Pony Steel Bar Clamp Fixture
Binding: Tools & Hardware
$10.99
Features:
- Hardened steel thrust bearing
- Mounts on any length 3/4-inch pipe
- No holes, rivets, or notches
- 1-3/4-inch-square clamp faces
|
? |
Jorgensen 50XXX 3/4" Pony Steel Bar Clamp Fixture
|
Customer Reviews:
Avg. Customer Rating: 4.3 / 5.0 
A Woodshop Standard: 
These versatile clamps are simple, strong, and a cost effective clamping solution. I recomend using black iron pipe as it is softer than galvanized and therefore the clamp grabs it better. Most stores that sell black pipe will cut and thread it for free. Have them thread both ends and use a cap from a pop bottle to cover the unused end. You can the use cheap pipe unions to join the two pipes to make a longer clamp.
Why buy Pony Brand? They are superior to their asian knockoffs in EVERY WAY. Pony pipe... more info
2nd best:
Very good, sturdy clamps. I only rated them 4 stars because Rocklers surefoot is a much better design with equal the quality. Use galvanized pipe, same price & it won't rust or stain your work. Also for some homebrewed clamp pads take some scrap 3/4" fir plywood, it's relatively soft & doesn't split, cut it into roughly 2" x 3 1/2" pieces. Then drill a 1 1/8" hole towards one end & paint it with polyuerathane. Slip it over the pipe & screw it to the clamp faces from behind with #6 x 3/4"... more info
Good product, but get some clamp pads, too:
I built a shed recently, making the door from tongue-and-groove decking boards. Before I could attach the 2x4 braces I needed to clamp the tongue-and-groove planks together. To fit big tools in the shed this door is 3-1/2' wide, so I needed a couple of big clamps. Two of these Jorgensen fixtures, plus a pair of 5' black pipes, did the trick quite nicely.
A few useful tidbits:
- The threaded black pipe recommended for use with these clamps comes with black grease to lubricate and deter corrosion. Clean... more info
Accessories:
Similar Products:
|
